Top discharge design fits most filters and its extra large clear lid allows for easy cleaning. Replace your old inefficient pump with this water moving dynamo. Comes with a 4.9ft cord 110v. Above ground pools Can only be used with sand filters or cartridge corrosion-proof reinforced thermoplastic housing , performance and quiet operation C-Clip Connector allows for easy disengagement of strainer housing in a matter of seconds for hassle-free maintenance High quality impeller with wide openings to prevent clogging by leaves and debris Clear cover lets you see when basket needs cleaning.
100% drip proof, heat-resistant double-sized seal for long motor life High performance impeller Drain plug for easy maintenance of pump 5555 gallon per hours Horsepower: 1 HP Voltage: 110V Port Size: 1-1/2. Cord Length: 4.9' ft long.1x 1HP Swimming Pool Pump. Model:SPPE 250 Power:1850W/2.5HP Voltage:110V / 60Hz Max. Flow:560 L/m IP55 INS CL. 50 C Amps:6.8 Head:Max 19m / 62.34ft Capacitor:25 F Inlet:1.57'' (40mm) Internal / 2'' (50mm) External Outlet:1.57'' (40mm) Internal /2'' (50mm) External Pipe Compatibility:Fit 40mm(1.57 inch) plumbing internally and 50mm(2 inch) plumbing externally Noise Level:<65dB Package Size:600 x 205 x 350mm / 24'' x 8.07'' x 14'' (L x W x H) Weight: 10.2 kg / 22.5 lbs Package Content 1 x Swimming pool pump SPPE250 1 x User's Manual. Our machine does not allow you to disassemble the cable.
This product is the highest standard of UL certification. If you wire it yourself, the machine will not work properly. Thank you for your cooperation.
Model: WCP1500A Power: 2Hp/1.5Kw 13.5amps Speed: 3450 Rpm Maximum Flow: 124GPM (470L/M) Features: Bathtub pump with single phase motor, thermal overload protector and air switch are completely insulated. They could run continuously for long time.
They are economical, quiet and compact used in whirlpool bathtub or spa systems. This Water pump equipped 115 voltage.
WCP1500A is powered by a high quality TEFC moto, as know as Totally Enclosed and Fan Cooled. The advantages to has a TERC moto are: First, air is not drawn into the motor for cooling and therefore the windings stay clean and dry. Two, the windings are protected against direct entry of wind driven rain, directed spray, and splash from the ground.Three, insects and other vermin cannot enter the motor. And four, TEFC motors protect the single phase switch keeping it clean and dry. Class B Pump body: Reinforced ABS. Impeller: Plastic/Noryl Motor Housing: Aluminium Mechanical seal: Stainless steel/Carbon-ceramic. Problem Description:The Pump Pressure is low; The Pump loses Pressure after being energized; Pump is running, But no water coming out. The pump head is not filled with water, causing the pump to run without water. During the installation process of the pump, the inlet and outlet pipes are not tightly sealed, and the air leaks inside the pump head. During the operation, the air inside the pump head is pulled in, resulting in insufficient internal pressure, weak pump pressure, no pressure on the pump, no water. Solution: When pumping water, the pump head is filled with water; the pump head transparent cover is tightened; the water pumpinlet and outlet joints are installed, and the raw material belts are tightened when the pipes are installed to prevent air leakage at the joints of the pipes. Inlet and outlet joints wrapped around the raw material tape, beware of leaks.
Tightening when installing the inlet and outlet, beware of leaks. The pump head transparent cover is tightened to prevent air leakage and water seepage. Problem Description: Pump motor trip.The water pump motor enters water or pump operating environment is excessively humid, and causing the motor to short-circuit and burn. The pump prevents the inlet from entering the water and burns the motor.
Problem Description:There is Water in The Pump. Our company carries out a full inspection (pumping) of the water pump, and it might result in some package still leave some water in it, It is normal. Problem Description: The Pump stop working suddenly. Our company's products are equipped with temperature protection device, when the motor temperature is too high, the temperature protection device will start, It will stop pump working, if the motor is shut down in the normal operation process , generally there is foreign matter inhalation in the pump, resulting in the impeller stuck, motor temperature rise , pump stop working. Clean up the waste inside the filter screen of the water pump regularly to prevent the waste foreign matter from flowing into the water pump to jam the impeller.Disassemble the pump body, clean up the foreign matter on the back of the pump body to ensure that there is no foreign matter blocking the impeller, and re-assembly can be reused. The foreign matter of the pump impeller and the diffuser is matched with the foreign matter, causing the impeller to be stuck and cleaning the foreign matter. Our 30-day Satisfaction Guarantee assures our customers that they will receive all orders promptly and exactly as described. Used items will not be accepted for return. We will reply you ASAP. Our aim is to provide Top Level Customer Service, so we will try our best to solve any problem. The item "Above Ground 1/1.5/2.5HP Swimming Pool Water Filter Pump 110-240V Motor Portable" is in sale since Friday, January 11, 2019. This item is in the category "Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Pool Equipment & Parts\Pool Pumps". The seller is "famorebo" and is located in Monroe Township, New Jersey.
This item can be shipped to United States.